Buy at IKEA "SNUDDA": about 5,- Euro
(or use something similar)
Cut from the small board two pieces off. About 5cm as showen.
The middle part is waste.
Big board and small cutted board.
Drill two holes in each small part.
Screw the small parts on the big board.
Result of the attached small pieces. (bottom side)
Result of the attached small pieces. (up side)
Use anti-slip band if you like for the up side. (about 3,- Euro)
If you like, you can attach another piece as showen for stabilization.
(cadge it at the hardware store) ;-)
Take care that the screws are not going through!!!
0 comments:
Post a Comment